That's the problem with their QA methodology.
They carefully weigh each one to assure all the parts are inside, but that
doesn't mean they're soldered in.
Steve WB2WIK
-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of David Gilbert
Sent: Thursday, September 12, 2019 11:36 AM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Cushcraft/MFJ Traps
I'm sure I'll get accused of MFJ bashing, but I can't help passing on this
humorous anecdote.
A few weeks ago one of the owners of Elecraft posted a request for information
on how to troubleshoot a network analyzer sold by MFJ. He had already asked MFJ
tech support for advice, and they replied that he should open it up and see if
any loose parts fell out because that's what they would do.
73,
Dave AB7E
On 9/12/2019 11:22 AM, K9MA wrote:
> I recently ordered some replacement traps for my old A3S. One was
> defective, so I took it apart. I was appalled at the poor quality.
> While the original traps had several pop rivets, in addition to the
> coil screws, connecting the tubing to the plastic insulator, the MFJ
> version had only the two screws in the very end of the tubing. The
> coil wires were sometimes wrapped the wrong way around the screws, and
> some of the screws weren't even tight. Where the original coil was
> coated with some kind of thick lacquer, the MFJ ones were bare.
>
> The moral of the story is don't even think about going to the trouble
> of putting up an MFJ/Cushcraft beam without taking apart all the traps
> and fixing the above problems.
>
> 73,
>
> Scott K9MA
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|