All the control cables here are gray jacketed cable and hold up just fine.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://wiki.k1ttt.net
AR-Cluster node: telnet://k1ttt.net:7373
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Mike
& Becca Krzystyniak
Sent: Monday, October 07, 2019 17:31
To: towertalk@contesting.com
Subject: [TowerTalk] A Couple of Rotor/Coax Cable Questions
Greetings,
Years back I acquired a Yaesu 2800 series rotor. IIRC the control cable was
a pre-fabbed black jacketed PVC type cable.
A local is selling a NOS/NIB G2800 and I noticed the control cable is a gray
color now, and the cable is quite flexible. Having a bad experience with
gray jacketed coax before I was wondering if anyone has a Yaesu 2800 rotor
with this type of control cable on their tower now, and how it is holding
up?
My second question is related to the right way to dress out coax on a
HDX589MDPL tower. To keep the cable off the ground I think ~22' looped off
between each coax arm is correct. Any other advice or suggestions on this
woould be appreciated?
Regarding the coax itself I have a 350' run down and into the shack. I was
considering using a LMR600 or LMR900 sized coax to come down the tower and
over to a service panel? I'm concerned standard LMR is too stiff and as
such susceptible to damage from bending? I read pro and con using the -UF
variant instead? Again thoughts and comments or other options would be
appreciated.
Thanks
73's Mike K9MK/5
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|