Towertalk
[Top] [All Lists]

[TowerTalk] multi-sheave pulley

To: <towertalk@contesting.com>
Subject: [TowerTalk] multi-sheave pulley
From: "Jim Thomson" <jim.thom@telus.net>
Date: Thu, 14 Nov 2019 06:30:59 -0800
List-post: <mailto:towertalk@contesting.com>
Date: Wed, 13 Nov 2019 12:26:10 -0500
From: Dave Sublette <k4to.dave@gmail.com>
To: kj6y--- via TowerTalk <towertalk@contesting.com>
Subject: [TowerTalk] multi-sheave pulley


<The trouble is, at age 77 I no longer have the arm strength that I once
<had.  So,  I would like to use a multi-sheave system to reduce the force
<necessary to lift it off and reinstall it.  I have a two pully system which
<would reduce it to half, but I think I had better go with a three or four
<section system.

<All this to ask what is a good three or four sheave fully?  It only need be
<a two inch diameter. Or, a one inch would work also.  If you have any
<knowledge which one and where to get it, it would be appreciated.  In the
<meantime, I will do my own searching.  But, I thought it would be good to
<have the input of someone who has actually used what they recommend.

<As always, I look forward to the excellent advice that comes from this
<group.

<73,

<Dave, K4TO

### Use a ....cumalong.    Easy, and  much better  control  vs a lawn  tractor. 

http://ds-studio.co/cumalong-tool/    The  1st  pix, is  the  version  I have. 
It  has
the  2nd  hook  option.....  so you   double  up  on  the  cable....so  its  
only  half
as  long,  but  capacity  increases  from 1 ton  to  2  tons.  You then  also 
get
an  even  finer adjustment  for  a given  amount  of lever  pull.   An 88  lb  
rotor
would  be a piece of  cake. 

##  I  use  a  multi  sheave /  rope  setup  to  get a yagi  to top  of  tower, 
 then  the  same
cumalong  to do the  last few  inches.    Grnd  crew lifts  yagi  up to  top  
of  tower,  then  I
hook the  cumalong  to a 2nd quick  rls  shackle.   Grnd  crew  then  goes  
home.   I  lift  yagi
the  last little  bit....  then....using  my  hb  version  of  the  infamous  
F12..easy  on  mounting
scheme,   mate  the  horz boom  plate  to the already installed vert mast  
plate. 

Jim  VE7RF
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>