Bill,
Nice work. And now you'll burn less oil because the rings will seat!
73,
Steve
N6SJ
-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of w6rgs@cox.net
Sent: Friday, April 24, 2020 7:23 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Widening tower mast opening.
Thank you to those that replied.
Just finished honing out the mast opening with an engine cylinder honer. The
type with the 3 adjustable arms, each with an abrasive stone. Took 5-6 passes
and the galvanized mast fits perfectly now. Sprayed some teflon inside the
smooth-as-silk mast opening. Mast turns freely with no hangups.
73
Bill W6RGS
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|