Thank you Gene...very good to know.73,Gary K9GS
-------- Original message --------From: Gene Smar <ersmar@verizon.net> Date:
7/17/20 11:44 PM (GMT-06:00) To: 'Gary K9GS' <k9gs@gjschwartz.com>,
towertalk@contesting.com Subject: RE: [TowerTalk] Waterproofing panel mount N
connector? Gary: Here's a link to the assembly manual for the K1FO 439 MHz
ATV Yagi
https://directivesystems.com/wp-content/uploads/sites/2/2019/09/DSEFO432-25ATV-H.pdf
. I own one and recall that its feed is an N connector. Page 8 includes a
warning NOT to apply any kind of sealant to the connector assembly other than
Krylon (R) Clear Coat. Good luck. 73 deGene Smar AD3F-----Original
Message-----From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf
Of Gary K9GSSent: Friday, July 17, 2020 10:41 PMTo:
towertalk@contesting.comSubject: [TowerTalk] Waterproofing panel mount N
connector?I'm looking for ideas on how to waterproof a panel mount N connector
used outside on a homebrew antenna. It's the back side I'm thinking
about.73,Gary K9GS
______________________________________________________________________________________________TowerTalk
mailing
listTowerTalk@contesting.comhttp://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|