On 9/29/20 8:52 AM, Charles Morrison wrote:
No. Outside.
So you have a small bump in diameter. Model it as such. Add a short 1
segment wire that is the diameter of the swaged part.
realistically, if it's a "tiny" part of a wavelength, it's not going to
make much difference.
On Tue, Sep 29, 2020 at 11:49 AM jimlux <jimlux@earthlink.net
<mailto:jimlux@earthlink.net>> wrote:
On 9/29/20 8:31 AM, Charles Morrison wrote:
> Is there an accepted reduction percentage that is used ?
> How do you model the swaged portion of tubing ?
>
> The published HyGain models do not account for it in a separate
tubing
> section, so no hints there.
Isn't the shrunkdown part inside another element? If so, it's not in
the
circuit.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com <mailto:TowerTalk@contesting.com>
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|