I assume that the shield is just on reed switch wires. It's easy to purchase
two conductor shielded cable or even use coax and the motors can be run with
semi-inexpensive THHN. If you have a long run you can use larger gauge for
the motors to minimize voltage drop. BTW if you use a Green Heron controller
the shield may not be necessary.
John KK9A
n6ta wrote:
M2 cable for the OR2800 is $1.97/foot regardless of the length. It is 2, 12
gauge and 2, 18 gauge shielded in a PE jacket. Said to be custom made. Any
known alternatives for such a cable? I suppose I could look for more
conductors and not use them, but the feedback must be shielded.
Tnx,
AL N6TA
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|