Towertalk
[Top] [All Lists]

Re: [TowerTalk] Long Term Connector Reliability

To: "k7nj@awinets.com" <k7nj@awinets.com>, "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Long Term Connector Reliability
From: n1bkb--- via TowerTalk <towertalk@contesting.com>
Reply-to: n1bkb@aol.com
Date: Fri, 22 Jul 2022 22:54:58 +0000 (UTC)
List-post: <mailto:towertalk@contesting.com>
 One example:  As I've done with other antennas and coax runs over the years, I 
wrapped the PL-259 connector linking the run of RG-213 to my 4-el yagi with 
"Coax-Seal" (a moldable, probably thiokol or similar material based tape) when 
I put it up on my tower in 1992.  When I moved in 2014 and disassembled 
everything when I took it down, other than the fact that it was a pain to 
remove the long-weathered wrap from the connector, the internal connection to 
the silver plated PL-259 looked just as shiny and new as it did the day I 
installed it.  On the other hand, all the other the Krylon clear painted 
hardware on the beam showed signs of corrosion.  That QTH was about 15-miles 
from my present location in Southern Calif ... probably a similar climate to 
what you experience in Na'ale.
73,
SteveN1BKB
 
 
-----Original Message-----
From: k7nj@awinets.com
To: towertalk@contesting.com
Sent: Fri, Jul 22, 2022 3:06 pm
Subject: [TowerTalk] Long Term Connector Reliability

After over 25 years I've found some problems with connector conductivity at
my 4X4NJ station.  I would be interested in knowing about experience that
any of you may have with reliable connector conductivity for  similar time
periods. This is primarily with PL-259, N-Type, and hard-line  connectors
and associated adapters.  In particular, any experience with the following
would be helpful:

1.      Nothing done to ensure conductivity

2.      Silicon grease

3.      Penetrox (or similar)

4.      "STUF" dielectric water proofing filler

I'm interested mainly in actual experience that you have had after many
years of using any of the above, or other, methods.  Please note that I'm
not seeking methods for waterproofing - just in keeping the connection
between mating surfaces highly conductive assuming waterproofing is good.

73, Riki K7NJ



-- 
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>