Thanks, Steve. I'll take a look at Yagi Mech.
73,
... Joe, W4TV
On 2022-07-29 11:54 AM, Steve Maki wrote:
A method I've used (albeit a bit roundabout) is to use Yagi Mechanical
to determine the individual element resonant frequencies (for the
constant diameter elements), and then do the same with your tapered
elements and adjust tip lengths to get the same resonant frequencies.
-Steve K8LX
On 7/29/2022 9:48 AM, Joe Subich, W4TV wrote:
I have some 6M Yagi designs with uniform element diameters
that I would like to build using tapered elements I have on
hand from the aluminum pile.
Does anyone have a pointer to converting the uniform element
lengths to an arbitrary taper schedule?
73,
... Joe, W4TV
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|