Does anyone know of a source for the small plastic gear that fits on the
multi-turn pot inside the Tic-Gen ring rotor motor box? The one that lost some
teeth
had 55 teeth, was 7/8 inch OD and had a metal insert to fit the 1/4 inch
shaft of the pot. I have a replacement from the pot removed from a
slave motor which didn't need the position indicator, but I would like
to have a replacement for just in case. These motors were late 1990's
vintage, with the sheet metal box, and the 1022 size ring.
I don't want to have to go to the external pot assembly TIC-Gen uses now.
Terry N4TZ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|