Towertalk
[Top] [All Lists]

Re: [TowerTalk] Looking for typical size attic info

To: Henry Pollock - K4TMC <kilo4tmc@gmail.com>
Subject: Re: [TowerTalk] Looking for typical size attic info
From: Mpridesti via TowerTalk <towertalk@contesting.com>
Reply-to: Mpridesti <mpridesti@yahoo.com>
Date: Mon, 13 Feb 2023 09:18:40 -0500
List-post: <mailto:towertalk@contesting.com>
Thanks Henry. Good suggestions!

Certainly one challenge would be just building the antenna in close quarters:)

Regards,

Mark, K1RX


> On Feb 13, 2023, at 9:16 AM, Henry Pollock - K4TMC <kilo4tmc@gmail.com> wrote:
> 
> Mark,
> 
> You might consider a 2-element Hexbeam.  A 20-10 Hexbeam has a turning
> radius around 10 to 12 ft which could fit in some attics.  To make it fit
> higher in tight attics, consider mounting it upside down, making it look
> like a normal umbrella.
> 
> 73,
> Henry - K4TMC
> 
> 
>> On Mon, Feb 13, 2023 at 8:42 AM Mpridesti via TowerTalk <
>> towertalk@contesting.com> wrote:
>> 
>> Looking at the HOA/condo situation as I get older and wonder what are the
>> typical size attics for putting, ideally, a small rotating Yagi for 20-10
>> m. Key question is what the biggest turning radius one might get?
>> 
>> 
>> Regards,
>> 
>> Mark, K1RX
>> 
>> 
>> _______________________________________________
>> 
>> 
>> 
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>