I acquired some used Rohn 45G in very good shape and will be going up 50
ft. Antenna will be stacked 2 x 9-el for 2m. I'm following the Rohn
engineering guidance very closely: base is a new R-SB45G buried in the
prescribed concrete block along with GAR30 guy anchors, also in
concrete. I have the older style guy bracket for 45G that has (very
expensive!) TB45D torque bars
<https://www.3starinc.com/rohn_45g_torque_bars_for_use_with_guy_bracket_r-tb45d.html>
along with several hundred feet of brand-new 1/4 in EHS for the guys.
According to the Rohn instructions, however, I can't use EHS cable
that's greater than 3/16 in:
https://www.3starinc.com/manuals/ROHN_Torque_Bar.pdf
This means I'd have to buy either smaller EHS cable or their newer guy
bracket that doesn't use torque bars. I'll do this if I have to, but I'd
sure like to understand why 1/4 in EHS is a deal-breaker for the torque
bars. QTH is north Florida so I want to make the setup as storm-proof as
practical. Any insight appreciated.
Mike WB2FKO
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|