The tubular tower that I was looking for is actually a MA-550. The UST
documents call for a hole 3x3x6 deep for the base. I would prefer to
use a 36 inch auger. Has anyone done this? The hole would need to be
7.64 ft deep to account for the rounding of the corners to achieve the 2
CU yards of concrete.
I would like to motorize the tilt over feature to be used in the field.
I am looking for recommendations.
I you have other helpful hints I am all ears!
Mike W0MU
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|