Is this what you're looking for?
Ham2/3/4/T2x internal wiring:
#1 large black, small black, brown ---> BLACK --GND & SOLENOID
#2 large yellow ---> WHITE --SOLENOID
#3 green ---> GREEN --POT (+)
#4 blue ---> BLUE --MOTOR
#5 orange ---> ORANGE --R LIMIT & MOTOR-MID
#6 small yellow - --> YELLOW --L LIMIT
#7 white ---> BROWN --POT (-)
#8 red ---> RED --MOTOR
Source: Craig at C.A.T.S - rotor-doc.com
-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of
n5xz@earthlink.net
Sent: Friday, August 30, 2024 4:23 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Hy-Gail TailTwister plug pinout
I recently purchased an unused TailTwister rotator for $20(!). I have been
using T2X's rebuilt by Norm's (I think) where the original terminal strip was
replaced by a plug/socket. I am 'assuming' they are wired the same but I don't
have a pinout to confirm before I connect the old plug to the new socket. Does
someone have a pinout I can use to compare and double check first? It is in a
'current' manual...I only have an old manual before the plug...
Thanks,
Allen R. Brier N5XZ
1515 Windloch Lane
Richmond, TX 77406
713-705-4801
--
This email has been checked for viruses by AVG antivirus software.
www.avg.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|