Yup! Exactly what I used.
Just remember... You cant *SADDLE* a *DEAD *horse.
In other words.... The *saddle always goes on the live end.*
Jim W7RY
On 9/26/2024 2:24 PM, Jon Zaimes, AA1K via TowerTalk wrote:
You also may use clamps on larger sizes. Have these on one of my towers.
https://rfconnection.com/wp-content/uploads/2017/08/355.pdf
73/Jon
Jon P. Zaimes, AA1K
Tower climber for hire
http://www.aa1k.us/
Cell: 302-632-2353
Reviews of AA1K tower work on eham
website:http://www.eham.net/reviews/detail/12922
Hug your favorite tower every day, and always stay connected to it.
On Wednesday, September 25, 2024, 8:10 PM, RVZ via
TowerTalk<towertalk@contesting.com> wrote:
Thank You to everyone who replied on "how to clamp Philystran HPTG 1200I the small 3/32" diameter cable". What I
should have included for those not in the know is that "there are no pre-forms available for this small size
Philystran". If there were pre-forms available I'd surely use them. Therefore, small wire clamps are
recommended. I was happy to hear that hams have been successful using wire clamps on this small size Philystran for more than 20
years so I plan to do the same. Thanks again for the replies! 73, Dick- K9OM
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
Thanks and 73, Jim W7RY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|