Re: [TowerTalk] swaging tool

["Richard (Rick) Karlquist" <richard@karlquist.com>]

I bought a muffler pipe expander at Harbor Freight.  It had no effect on 
2 inch 0.050" wall aluminum irrigation pipe/tubing (which is NOT 606X 
alloy) no matter how much I tightened the wrench.  Obviously it can be 
swaged with some machine tool that is probably beyond the lone ham.
Rick N6RK

On 2/28/2025 8:56 AM, Steve Harrison wrote:
> On 2/28/2025 8:48 AM, Ed Stallman wrote:
> > Jim, I tried the same thing with 2" OD 1/8" wall , took the tubing to
> > a muffler shop . They tried  twice and both times the tubing split .
> > Maybe if he would have went slower?
> Your problem was likely that your pipe was ALREADY hardened, if it was
> 6061-T6 or 6063.
>
> You can easily expand steel tubing like that if you heat it red-hot; but
> I doubt you can do that with aluminum, and it melts before it ever glows
> red-hot, anyway. The trick would be knowing when it's hot enough before
> it melts.
>
> Steve, K0XP
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk