Towertalk
[Top] [All Lists]

Re: [TowerTalk] Loading Coils

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Loading Coils
From: David Gilbert <ab7echo@gmail.com>
Date: Fri, 1 Aug 2025 15:19:10 -0700
List-post: <mailto:towertalk@contesting.com>

Yes ... that.

Nickle has about 4 times worse electrical conductivity compared to copper, and the skin depth at 30 MHz is about 20 times thinner (about 12 microns for copper versus about 0.65 for nickle).  ChatGPT tells me that standard nickle plating is roughly 5 to 10 microns thick , and that even low cost nickel plating is typically 1 to 2 microns thick.

The math agrees with you.

I wonder if anyone has made measured comparison of his coils versus a similar copper one.

Dave   AB7E



On 8/1/2025 2:29 PM, Wes wrote:
I would need some convincing that nickle plating is a good idea.

Wes  N7WS


On 8/1/2025 10:06 AM, David Needham wrote:
Hello,

If any of y'all are in need of any inductors (or loading coils) for your 80
or 160m verticals, my good friend Gaylord Gasque, N6SF, has started
manufacturing several models.

I have tested several of these at my QTH.  I really like the ones with the
built-in mounting hardware he calls the Q-Coil furniture.

With B&W and MFJ no longer marketing coils, Gaylord took it on himself to
supply the amateur community.

His website is https://Qcoil.net <https://qcoil.net/>

I hope you'll check it out.


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>