The CEO/owner of RigExpert lives in Canada.
John KK9A
John Keating K7LY wrote:
Jim and Dan, thanks for the comments and suggestions. I ran Zplots TL
params on data from my TAPR VNA and saw no unusual results. I rescanned
the cable with the RigExpert but viewed the data on AntScope2 software
which showed the step response reflection coefficient stayed at zero.
AntScope has a specific cable parameter selection for FSJ4 cable, while
the RigExpert unit itself does not (it only permits selection of a
limited set of cables and velocity factors). I suspect the anomaly is
due to the algorithm or parameters stored in the unit being different
from those in the PC software. I sent an inquiry to RigExpert but don't
expect to hear back given the situation in Ukraine. Meanwhile I will
proceed on the basis that the cable is in good condition.
73, John K7LY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|