Another option, if you have a rotator controller that emulates the
Hy-Gain DCU control set is the N1DKO Rotator-controller-controller
(provides a network interface w/WiFi for a HY-Gain compatible
controller).
73,
... Joe, W4TV
On 2026-03-30 5:05 PM, Mike Fatchett W0MU wrote:
You should be able to run PSTRotator from a pc in the barn with a USB
controlled controller ie GH, if you have network out there and remote.
The program might allow control from another pc too. I have not used it
in a long time but it worked really well when I did.
W0MU
On 3/29/2026 12:45 PM, George Collins via TowerTalk wrote:
I want to thank everyone that replied to my question about controlling
rotators on distance towers. The response was overwhelming with many
different approaches. I am going to try locating a controller in a barn,
100 feet from the tower where I have AC power, and running CAT-5 cable as
control and position lines to the shack approximately 350 feet away.
I am
hoping that this will get me operational quickly and then I can work on a
wireless solution, perhaps using a WiFi connection to the barn, as time
allows.
Please pardon my slow response. I really appreciate everyone taking the
time to share their experience and recommendations.
73,
George, KC1V
FN31
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|