Towertalk
[Top] [All Lists]

[TowerTalk] ionosphere Re: More Interference Pattern

To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: [TowerTalk] ionosphere Re: More Interference Pattern
From: Brian Beezley <k6sti@att.net>
Date: Thu, 16 Apr 2026 17:24:21 -0700
List-post: <mailto:towertalk@contesting.com>
Jim Lux said:

"There are a fair number of people who have done polarization diversity
receiving. A big X is popular (because it's easier to build than a big cross, and the two sloped elements have similar ground effects)"

I've been interested in polarization diversity for HF reception for years, but I've never done anything about it. I too thought sloping dipoles would be the way to go and for the same reason. I'd slope them from each side of a single pole.

However, when fooling around on my computer one day with a tilted linear array over ground, I selected circular polarization by mistake. Before I corrected it, I noticed that the axial ratio was nonzero. That's impossible with linear elements, I thought. I reduced the model to a simple dipole tilted 45 degrees and still got a nonzero axial ratio broadside to the antenna. Within a few minutes I had hung a folded dipole for the FM broadcast band from my ceiling fan. It was easy to verify than when sloped, the antenna received CP. What generates it is the image antenna below ground, which is perpendicular to a wire sloped 45 degrees, together with the phase delay for the ground reflection. Imperfect ground reflection yields elliptical polarization, which depends on the ground constants. I wrote it up here:

https://k6sti.neocities.org/tilted

A lot of people use slopers (quarterwave wires) or sloping dipoles on HF. Directivity is off the end but CP occurs broadside so it might not be obvious. Still, I've never seen a fading benefit reported. You'd think someone would have noticed.

So you don't need two wires to get CP. But with a single wire, you're stuck with RCP or LCP and no adjustment of axial ratio. What I always had in mind for HF CP was adaptive S/N maximization using two antennas. An algorithm adjusts the amplitude and phase of one signal path to maximize S/N. I'm not sure the best way to measure S/N, but if you adjust for minimum signal internally then flip the phase 180 degrees for the output signal, you at least maximize the amplitude, if not S/N. This system shouldn't be bothered by each antenna itself being CP.

I'm not sure how much benefit this system would provide in practice. On 160m where fades can be excruciatingly long, it could help a lot if the fade was due to crosspolarization. At the very least it would be fun to play with.

Brian

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] ionosphere Re: More Interference Pattern, Brian Beezley <=