Hi Gang,
As I get closer to finishing the remaining modules for my K2 and planning
for the June VHF contest, I have a question. Has anyone built a DEMI
144-28 board and transverter switching into an EC2?
I figure that there would be room for switching for at least 8
transverters, the board, and another switch that would provide a bypass to
HF. To make this more clear, I figure that 50-432 bands would use a 28MHz
IF and not go through the DEMI board, whereas 903-10G would use the board.
As for 144, the DEMI board could be switched to an amp for that band. Since
the signals in the box would all be 28 or 144 MHz nothing too exotic should
be required.
Right now, I will only be using this for a couple of bands but I fully
intend on getting them all!
If you have built something like this, I would love to see your schematic
and a photo or two!!
73,
Mark K2QO
K2 543
|