[Top] [All Lists]

[VHFcontesting] ic-910h icom dsp unit ut-106 installation

To: <vhfcontesting@contesting.com>
Subject: [VHFcontesting] ic-910h icom dsp unit ut-106 installation
From: STEPHEN L SALA <k7awb@msn.com>
Date: Sat, 5 May 2007 16:27:34 -0700
List-post: <mailto:vhfcontesting@contesting.com>
I am trying to install a main dsp unit inside the 910.  the dsp unit comes in a 
vinyl sheath with cutouts for the cables.  since the dsp unit has a grounding 
spring unit on its bottom, it appears to me that one removes the circuit board 
from the vinyl sheath and installs it with its metal spring to the metal 
chassis.  Wonder how you ic-910h owners did it?  the unit without the vinyl 
sheath is a little loose when I install the dsp metal cover with the two screws 
to help hold the dsp unit in.  the instructions says to use the velcro to hold 
it to the underside of the dsp metal cover, but I did not have in any in the 
suggestions on this matter. I thought it would be a ten minutes job.  hi  hi
Stephen L. Sala (Steve) K7AWB Nine Mile Falls, WA DN17es
VHFcontesting mailing list

<Prev in Thread] Current Thread [Next in Thread>
  • [VHFcontesting] ic-910h icom dsp unit ut-106 installation, STEPHEN L SALA <=