I run my DEMI 222/28 transverter with mine. Basically the setup is identical to
the IC706 I used to run the same Transverter with. One thing I did notice is I
use the TIB from DEMI and this sends back an ALC voltage to control the power
output, the IC 7000 did require a re-adjustment of this to bring the transmit
level into the Transverter to the correct level. Keying is again the same as
the IC706, one key circuit for HF/50 and one for 2/432. You can't really drive
anything off the key circuit as the amperage it can sink is the same low value
that the 706 uses. I use a simple Radio Shack 12v reed relay for the job, it
has served well for over 10 years now with this setup. With this setup my
IC7000 can go into my rover for January and handle 50 through 432, the nice
thing is the voice keyer is built in and with the addition of a 4 button switch
box you can really utilize it well, similar to the IC756 in that manner.
Tom - K9TMS
-----Original Message-----
>From: Nate Duehr <nate@natetech.com>
>Sent: Jan 30, 2008 9:46 PM
>To: VHFContesting Remailer <vhfcontesting@contesting.com>,
>cq-contest@contesting.com, vhf@w6yx.stanford.edu
>Subject: Re: [VHFcontesting] Icom 7000 vs other HF/VHF/UHF rigs
>
>
>On Jan 30, 2008, at 8:46 AM, k4gun@comcast.net wrote:
>
>> I love mine. The voice keyer is really nice for roving. Its fairly
>> easy to use once you get used to it. It does take some time to get
>> everything figured out, but once you do, its no problem.
>>
>> I wont go into the DSP because you already seem to know, but I will
>> just say the noise blanker alone is worth the cost. Other than
>> that, the display is pleasing to the eye and easy to see. The auto
>> and manual notch filters work very well. I also get outstanding
>> audio reports from other stations. A common comment from some guys
>> with high end audio is "Whatever settings you have are right. Don't
>> change a thing!"
>>
>> I hope this helps.
>>
>> Steve
>> K4GUN
>
>Anyone driving transverters with one? How is the connectivity?
>Different pins for keying different bands (for pre-amps, etc.)?
>
>--
>Nate Duehr, WY0X
>nate@natetech.com
>
>p.s. I'm not on all those other lists, so if they have moderators they
>can choose to post this, otherwise the reply will go in the bit-
>bucket, which is fine with me... too many lists already here...
>
>
>
>_______________________________________________
>VHFcontesting mailing list
>VHFcontesting@contesting.com
>http://lists.contesting.com/mailman/listinfo/vhfcontesting
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
|