Hi all,
Here are my current grid & time estimates for roving in this weekend's
contest:
Saturday:
1. FN05wx -- Bissett Creek Rd, around 1800-1900utc (2-3pm EDT)
* 15min to move to new grid - 6,2,.70 on loops in transit
2. FN06wa/xe -- Bissett Creek Rd, 19:15-20:15utc (3:15-4:15pm EDT)
* 30-45min to move to new grid - 6,2,.70 on loops in transit
3. FN16fc -- around 2100-2200utc (5-6pm EDT)
* 3hours or so to move to new grid -- 6,2,.70 on loops in
transit
4. FN15xl -- Diefenbunker west & south facing, around 0130-0215utc
(9:30-10:15 EDT)
* 15 minutes to move to other side of ridge, same grid
5. FN15xj -- Carp Ridge east facing, around 0230-0300utc (10:30-11pm EDT)
Sunday:
1. FN15xl -- south facing, around 1300-1330utc (9-9:30am EDT)
* 1 hour to move to new grid -- 6,2,.70 on loops in transit
2. FN14xw -- Numogate, around 1430-1530utc (10:30-11:30am EDT)
* 1.5hours to move to new grid -- 6,2,.70 on loops in transit
3. FN24dw -- Oxford Mills, around 1700-1800utc (1-2pm EDT)
* 1 hour to move to new grid -- 6,2,.70 on loops in transit
4. FN25bh -- Kanata hill, around 1900-2000 (3-4pm EDT)
* 30 minutes to move to new grid -- 6,2,.70 on loops in transit
5. FN15xl -- Carp Ridge/Diefenbunker area looking south, 20:30-21:30utc
(4:30-5:30pm EDT)
The SSB setups are:
6m: 100w into square loop (50.150 ±)
2m: 50w into loop / small beam (switched) (144.250 ±)
220: 25w into loop / small beam (switched) (222.150 ±)
70cm: 20w into loop / small beam (switched) (432.150 ±)
33cm: 30w into loop yagi (903.100 ±)
23cm: 25w into loop yagi (1296.100 ±)
The planned FM setups are:
2m: 45w into vertical (146.58)
70cm: 20w into vertical (coordinate on 2m)
33cm: 5w into a colinear vertical (coordinate on 2m)
+ 220 available on HT (coordinate on 2m)
I will be on 144.250 on the :00 & :30 and 50.150 on the :15 & :45 when
stopped unless I am running the bands with another station (i.e. I
should be back in a couple minutes if I am not right there). I would
like to setup skeds, but I never seem to be able to keep them...
Information on previous incarnations of the VA3CDD/r is avialable at:
http://www.storm.ca/~ddenter/va3cdd-rover.html
The rover for this contest will be very similar to v1.2, except a Vibe
replaces the Golf and the rear loop mast is now on a trailer hitch mount.
Best of luck in the contest.
regards,
Dean -- VA3CDD/r
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
|