VHFcontesting
[Top] [All Lists]

Re: [VHFcontesting] Rover for June VHF

To: vhfcontesting@contesting.com
Subject: Re: [VHFcontesting] Rover for June VHF
From: Detrick Merz <detrick@merzhaus.org>
Date: Mon, 7 May 2018 20:58:05 -0400
List-post: <mailto:vhfcontesting@contesting.com>
Thanks for all the replies, on list and off. It's all been very helpful. I
think we'll go with a 11' 6" max height while mobile. It seems to be around
the average height you all are running, and it's all the same height I
already look for because that's how high our camper is so we're already
used to looking for that much clearance.

With any luck, we might (might!) be able to give it a test run this weekend
during the 6m sprint!

73,
-detrick
K4IZ

On Sun, May 6, 2018 at 3:55 PM, Detrick Merz <detrick@merzhaus.org> wrote:

> Howdy Folks,
>
> A few of us are planning to try June VHF as rovers. Never done VHF
> contesting before, and obviously not rover. But it sounds like fun so we're
> going to give it a go. Planning on 6m, 2m, & 70cm. Omnis in the bed of the
> truck, some yagis for stop-and-shoot. If you care, we're planning two
> rovers (two trucks), 2 ops in each, running limited class. I'm sure we'll
> cause all kinds of problems for each other doing it this way, but we'll
> learn a lot too. And camping is more fun with friends.
>
> Yesterday I finished up the base for securing a mast into the truck bed.
> The mast tubing recesses into this base and gets guy lines from near the
> top to 4 existing anchor points in the bed.
>
> The question of the day is: how tall is too tall for going down the road?
> The truck bed is 3' off the ground, and the tubing as it is is 10'. Is 13'
> too tall, should I cut the tubing down to 8'? Should be no problem on major
> roads, but I'm wondering about tree strikes on smaller roads.
>
> Thanks for any insight,
>
> -detrick
> K4IZ
>
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting

<Prev in Thread] Current Thread [Next in Thread>