I use Writelog normally for rtty On my FT1000MP by using the pkt/lsb
selection wired to the packet plug.
The system normally works well.
But with PSK I see just a very small blip in the tuning window and it's
very hard to tune.
If I get a strong signal I can see a dip between the peaks and when I
tune there I get good print.
If I select a narrower filter than 2.4 the peaks on the tuning window
disappear.
So what am I doing wrong? Which is the best choice in the mode selection
BPSK OR QPSK/LOWER OR UPPER???
thanks
------------------------------------------------------------
Don't cry because it's over, smile because it happened.
------------------------------------------------------------
Bill H. in Chicagoland
w9ol@billnjudy.com FireBrick@telocity.com w9ol@telocity.com
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|