WriteLog
[Top] [All Lists]

[WriteLog] Missing characters [SOLVED]

To: <writelog@contesting.com>
Subject: [WriteLog] Missing characters [SOLVED]
From: jrp@dimensional.com (Jeff)
Date: Sat, 3 Nov 2001 11:38:55 -0700
Thanks to everyone for all the helpful suggestions.

I switched my CW interface from the parallel port to a
serial port.  Everything is now working FB.

Well....there is this one thing that, while not a
show-stopper, is bugging me a bit.

I have a mono connection from the line-out pin
on my Icom radio to the line-in on the computer
soundcard.  But in order to use the CW decoder,
I have to configure it as stereo instead of mono
and just close the second window that pops up.
Anyone else experience this?

Thanks,
Jeff, KI0RO

On Friday 02 November 2001 17:16, Robert Ruvolo wrote:
> I had the same problem however my set-up is probably different then yours.
> I have an external CDROM that uses the parallel port. I  hooked the keying
> circuit to the CDROM parallel port thinking it was a direct feed through.
> Obviously not, cause hooking the keying circuit directly to the PC parallel
> port corrected the stuttering and missing dots and dashes. Hope this helps.
>
> 73 de Bob (KI6DY)
>
> ----- Original Message -----
> From: "Jeff" <jrp@dimensional.com>
> To: <writelog@contesting.com>
> Sent: Friday, November 02, 2001 8:21 AM
> Subject: [WriteLog] Missing characters
>
> > Hi,
> >
> > I recently installed Writelog and use the parallel port for
> > the computer generated keying.
> >
> > As I was getting getting set up for sweepstakes last night,
> > I noticed that the occassional dit or dah would get skipped
> > over when executing the macros.  I am not running any
> > other programs on this laptop computer.  The processor
> > is from the Pentium II family, so it should be fast enough.
> >
> > Any suggestions?
> >
> > Thanks,
> > Jeff, KI0RO
> > _______________________________________________
> > WriteLog mailing list
> > WriteLog@contesting.com
> > http://lists.contesting.com/mailman/listinfo/writelog


<Prev in Thread] Current Thread [Next in Thread>