This weekend I was playing with a three station Writelog network and I just
could not get it working quite right -- I wonder if anyone else has seen
this and can offer any advice. Here is what was happening:
The Windows network seemed to be working just fine. All the PC's could see
all the others, look at the shared directories, etc.
When I fired up Writelog and tried to create the network I could not get all
stations to talk with each other. A QSO entered on station A would show up
on B, but not C. A QSO entered on B would show up on A but not C. Then I
would take everything down and bring it back up, and some other combination
would result as I tried building the network differently. Sometime the
Networked Frequencies would work but not the QSO's. (Or at least I think, I
did not write everything down.)
Has anyone seen this type of behavior? What did you do to fix it? I actually
have seen this problem before but it "went away" and so I never bothered to
figure it out. Now, I can't seem to get it to go away.
Any and all ideas would be appreciated.
Scott/K7ZO and one of the operators at NK7U
|