Hi Dirk,
the problem is that the WL packet window does not allow to input the
ESC character/sequence required by your firmware. It is meant to be
run with a firmware that has a CMD: prompt.
I think the standard TNCs can be switched to use that mode (sri, can't
remember the name - I am no packet guru). In Europe this has the big
disadvantage that it does not support DAMA.
A good idea for the next version would be a menu item to send the
ESC character (ASCII 27 I believe) to the TNC from the packet window.
vy 73 Carsten, DL1EFD
P.S. Glad I run unassisted;-)
"Dirk Desloovere" <d.desloovere@skynet.be> schrieb am 13.03.02:
> Dear,
>
> I try to run a random tnc with writlog V10.29 using the packet window.
> This tnc runs errorfree with Logger 8.07.
> The tnc is is pwg tnc 2 using Frimware Version 2.7 software.
>
> When I start the packetwindow in WL I can see the start protocol with version
> and the checksum in the window. So the port (com 1 in my case) is
> communicating with the tnc.
>
> But when I want to give a command with such as esc i on4adz , or esc c
> on0ck by using the escape key the packet window closes.
> So I am unable to command this tnc.
>
> What is wrong ?
>
>
> Tnx
>
> ON4ADZ
>
>
>
>
> --- StripMime Report -- processed MIME parts ---
> multipart/alternative
> text/plain (text body -- kept)
> text/html
> ---
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
________________________________________________________________
Keine verlorenen Lotto-Quittungen, keine vergessenen Gewinne mehr!
Beim WEB.DE Lottoservice: http://tippen2.web.de/?x=13
|