When I clicked on a call in the receive window the cursor went to the RST
field. This is a problem
in CQ (run mode). When you click on the call the cursor should remain in the
call field so when the
enter key is pressed the exchange is sent. I had to manually put the cursor in
the call field in
this case. I look in the help and all the configuration dialogs I could and
didn't see a way to
change this behavior. It works properly in SSB and CW because you manually type
in the call. I could
do this in RTTY but that negates the advantage of point and click data entry in
RTTY.
Is this a program problem or did I miss a configuration screen??
73 Dave N4IG
PS the BARTG was my first try with RTTY contesting.
|