WriteLog
[Top] [All Lists]

[WriteLog] Problems re-installing Writelog

To: <writelog@contesting.com>
Subject: [WriteLog] Problems re-installing Writelog
From: don.wsixffh@verizon.net (Donald Eriksen)
Date: Sun, 18 Aug 2002 09:18:06 -0700
There's really not enough information to help you at this point. Your
problem may not be with writeLog at all. Questions that come to my mind are:

1. By upgrading the motherboard I assume you installed a whole new MB.
Correct?

2. Are you having any problems with other programs? Have you tried them all?

3. If a new motherboard, did you re-load your operating system (Win 98 or
whatever was on your old drive?

I installed a new MB recently (keeping the old HD) and had all kinds on
problems, not all associated with WL, and finally called the MB maker for
tech. help. The first question he asked me was: "Did you re-install your
OS?"  (I was and am using Win98SE). Well, I felt a little dumb, I guess I
should have known, but then I'm no computer Guru. Re-installing Win98 solved
all problems.

Hope this helps, 73
Don W5FFH   don.wsixffh@verizon.net


----- Original Message -----
From: "Dez in Cyprus" <dez@cytanet.com.cy>
To: <WriteLog@contesting.com>
Sent: Saturday, August 17, 2002 10:46 AM
Subject: [WriteLog] Problems re-installing Writelog


> Hi All,
>
> Recently I upgraded my motherboard, but wanted to retain my existing
> hard-drive. The H/Drive had a fully functioning version of Writelog, which
I
> am subscribed to, (10.31).
>
> However upon running Writelog, the program appeared to start up okay at
> first, then when I tried selecting 'Start a new log' or 'Open recently
> used', the program hung.
>
> I decided the next step would be to un-install Writelog.
>
> Next I re-installed version 10.26, which is a full version (and not 10.31
> which was a subsequent upgrade).
>
> The installation appeared to have gone okay - no error messages were
noted.
>
> However when I try to run Writelog now, the program does not start, and I
am
> presented with the following error message in a dialogue box:
>
> WRITEL32 caused an invalid page fault in
> module MFC42.DLL at 0177:5f40d84d.
> Registers:
> EAX=00000000 CS=0177 EIP=5f40d84d EFLGS=00010206
> EBX=00000000 SS=017f ESP=006bf5a0 EBP=006bf5c4
> ECX=00007fff DS=017f ESI=01317530 FS=48d7
> EDX=00018ce4 ES=017f EDI=006bf60c GS=0000
> Bytes at CS:EIP:
> 89 48 58 8b 45 fc 3b 47 0c 7c cf 33 f6 39 77 0c
> Stack dump:
> 01232ee4 012314ac 00000000 00000300 0000001c 01317790 006bf654 012314ac
> 00000018 0000e80a 0041afac 006bf60c 012314ac 006bf834 006bf6d8 0041a7b0
>
> Any help greatly appreciated.
>
> 73
>
> Dez - ZC4DW
>
>
>
>
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog


<Prev in Thread] Current Thread [Next in Thread>