Same here!
Have never suffered any of the reported problems with Writelog & MMTTY 1.63
Mine's an old clunker Pentium 200 MHz, however I only use MMTTY on RX with
a 10 buck soundcard.
I generate the FSK for transmit from a Kantronics KAM run through Writelog,
(there's a method in my madness, honest).
73 GL
Dez - ZC4DW
----- Original Message -----
From: "joseph duerbusch" <jduerbusch@earthlink.net>
To: <writelog@contesting.com>
Sent: Monday, January 27, 2003 4:39 PM
Subject: [WriteLog] Writelog and MMTTY 1.63 No problem
> I have been reading the other messages about WL/MMTTY 1.63 all last week.
So during the contest this past weekend I looked for problems.
>
> No problems here. No extra characters sent. Buffers worked all the time.
If we all had a problem, then it would be safe to say it was the update, but
I had no problems. And, it seems like MMTTY 1.63 copies the very weak
signals even better than 1.62! Of course this could be a new antenna, or
conditions but it is really picking up the very weak.
>
> I am using a 1.7 Gig machine, 256 Memory, a $10.00 PCI soundcard.
Interface is a Rascal ($26.00 in kit form).
> Rig is a Kenwood TS-850S/AT with IRC 400HZ cw filter and using FSK.
Nothing special here.
>
> During the contest almost all stations send a CR/LF at the end of their
transmission. The one's that didn't really stuck out!
>
> my $.02 worth, cu in CQWPX.
>
> Joe K0BX
>
>
>
>
> http://www.qsl.net/k0bx\r\nk0bx@qsl.net\r\n
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>
>
>
|