From: K4IA@aol.com
To: n1eu@hotmail.com, writelog@contesting.com
Subject: Re: [WriteLog] Using USB/RS232 adapters for rig control
Date: Fri, 7 Nov 2003 08:12:36 EST
I tested that exact same cable for 2 radio operation and got it to work. I
don;t presently have it hooked up so I can;t compare my settings but I
don;t
recall it being difficult at all. I run XP Home and had a Field as Radio 1
with
the regular serial port connection and an FT100D as radio 2 on the USB.
Check to be sure you properly installed the USB driver software that came
with the cable. Then go to Control Panel - System - Hardware - Device
Manager
and click on the USB Device Controllers at the bottom. It should tell you
if
you have a problem with the install of the driver.
Radio k4ia
Craig "Buck"
Fredericksburg, Virginia USA
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/