Check the Help file's section on the INI file. There you will find the name
of the parameter which you can adjust for the number
of seconds that the bandmap entry will be displayed.
There is a similar entry for the packet spot window.
-- Eric K3NA
-----Original Message-----
From: writelog-bounces@contesting.com
[mailto:writelog-bounces@contesting.com]On Behalf Of Jim Jarvis
Sent: 2003 December 16 22:20
To: writelog@contesting.com
Subject: [WriteLog] bandmap timing
This may be a dumb question...but how do I set the
amount of time which spots are allowed to dwell on the
bandmap? In the point & click mode, it sometimes is
beneficial for mults not to go away for a longer time
than what is programmed.
I noticed this many times in CW, where the pileups were
large and I couldn't break the pileup with my 80m dipole...
I'd want to recursively revisit the mult, until things
thinned out a bit. Several times, they timed-out of the
window.
This is a comment, as I don't believe there's a setting:
...I noticed a need to fix the center frequency
of the display. Often, when pointing/clicking, the display
would dither just as I was clicking on a spot. The result
was the radio going somewhere other than intended. Not
clear why.
At the same time, there was no reason for the bandmap to
reposition itself. In most cases, it can be fixed on the
appropriate mode, and cover the necessary range.
n2ea
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|