The easiest way is to run with the super check partial window open. The
last station worked ends up being shown in this window after the Q is
complete. Then with you mouse double click on the call and it will populate
the QSO entry window.
Selecting a different band is done by using the Log Frequency button. Click
on it and it will allow you to enter the frequency and mode to set the radio
to. Then you can enter in the frequency window 1240M for 1240 and it should
switch to the new band and mode. Going back is just as easy. Open the
window again and enter 144200 to jump to the 2M calling freq. This
information is further explained in the help file under "Setting the Logging
and Duping Frequency". Hope this helps.
73,
Dennis J Hoffmeyer
KG6GIQ
-----Original Message-----
From: writelog-bounces@contesting.com
[mailto:writelog-bounces@contesting.com] On Behalf Of Richard C. Allen
Sent: Thursday, January 22, 2004 05:57
To: writelog@contesting.com
Subject: [WriteLog] Jan vhf
When I want to move a station/rover to another band
how do I avoid typing in the call and grid again?
Is there any way to go from say 144 to 1240 without
cycling thru 222, 420, and 903 on the way?
Richard W5SXD
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/