I ran NCQP with pen and paper. I figured I'd just play around a bit. About
8 hours later I put the pen down. Now I have a few sheets of paper. I tried
to put it into WL but ran into a problem. For some reason it would not
recognize the multipliers. I have 10.45, selected NCQP on startup, enter
fields look correct. Any ideas anyone?
Also, is there an easy way enter the times, when post-entering stuff like I
am?
Thanks,
Gary W2CS
Apex, NC (Chatham Co)
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com]On Behalf Of Edward
> Sent: Monday, March 01, 2004 7:05 PM
> To: Writelog Reflector
> Subject: [WriteLog] NC QSO Party
>
>
> I worked the North Carolina QSO party. I found when I tried to
> recalculate
> the score I would bring up the Station Set-Up page. So I am not sure my
> score ever got recalculated. I also noted I worked 68 contacts and the
> summary sheet shows 67. No DUPE was shown on the log printout. Otherwise
> the program worked fine and dandy.
> Ed KN4Y
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|