WriteLog
[Top] [All Lists]

Re: [WriteLog] CtCompatibleAccel=YES

To: "'Jon Suehiro'" <nn5t@attglobal.net>,"'WriteLog Reflector'" <writelog@contesting.com>
Subject: Re: [WriteLog] CtCompatibleAccel=YES
From: "Ric Plummer" <ricp@charter.net>
Reply-to: ricp@alum.wpi.edu
Date: Thu, 28 Apr 2005 12:23:35 -0000
List-post: <mailto:writelog@contesting.com>
Jon,
Go to Tools/Keyboard Shortcuts
Go down to F11 and change it to entryclear
This will now act as entry clear instead of CQ
Ric KV1W


-----Original Message-----
From: writelog-bounces@contesting.com
[mailto:writelog-bounces@contesting.com]On Behalf Of Jon Suehiro
Sent: Thursday, April 28, 2005 3:58 AM
To: 'WriteLog Reflector'
Subject: [WriteLog] CtCompatibleAccel=YES



After using WL by UPGrading for years, I just fresh re-installed while
replacing the aged hard-drive.

Installed WL1051Mfull provided by Ron at the time of renewal, then UPGraded
to WL1054CUPG (plus, MMTTYPlugin_V13).   Every thing seems back to the way
used to be.   Except one thing.

When CtCompatibleAccel=YES was added into [Configuration], my original
setting not only made F1 key for CQ-ing but also F11 for wipe QSO.
Currently I am getting CQ-ing on both F1 and F11 (Setup -> CW/RTTY/SSB
messages... indicates as F1&F11 to agree with the condition).

How can I make F11 as wipe QSO instead of Alt + Q ?

I looked at the old WriteLog.ini to see if I am missing, but don't see any
particular line ...   Nothing mentioned in Scot's site either.

Thanks for your help.

73 de NN5T, Jon


_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

<Prev in Thread] Current Thread [Next in Thread>