I am not sure that you need to do anything. If the CW RTS is NOT the same
as the rig port, then RTS should get asserted by default. I have a similar
W1GEE interface cable and all I had to do was:
Add the following to writelog.ini
[Rigs]
Icom IC-756PRO2=0x6e
That will override the default for the Pro III rig address. Choose
IC-756PRO2 in ports setup and you should be running.
Mike, W1NR
-----Original Message-----
From: writelog-bounces@contesting.com
[mailto:writelog-bounces@contesting.com] On Behalf Of John Muzyka
Sent: Thursday, June 23, 2005 5:48 PM
To: writelog@contesting.com
Subject: [WriteLog] RTS Line
I have just got a new Pro 3 rig and have had to get an interface for the
rig-pc, the Icom interface was a fortune I so got a G4ZLP interface
(www.ham-radio.ch) I have been told I need the programme to turn on the RTS
line so that the interface which is built into the 9 pin plug will get its
power, how is this done in WL ???? once I find this out I might be able to
get the rig to talk to the pc Cheers John G4RCG
---------------------------------
Yahoo! Messenger NEW - crystal clear PC to PCcalling worldwide with
voicemail _______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|