Did a little playing around today, and here's what I have found:
If I start CW decode, then go into Sound Board Options and Enable
Recording Loop first, I get an error saying the sound card is in use.
If I enable Recording Loop first, then Start CW Decode, I get no
print in Mono (1 radio), but if I set it to Stereo (2 radios) I do
get print, after selecting Microphone instead of Line In (WL switches
it when I start recording audio).
Anyone else ever experience this or have any ideas?
Tnx,
Barry
--
Barry Kutner, W2UP Internet: w2up@mindspring.com
Newtown, PA Frankford Radio Club
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|