Kevin
In the Writelog V10 Program section ( Start/Programs/Writelog )there is an
application called Soundboard mixer control.
Bring it up nad at the top you can sellect the sound board to use for
various function of
writelog. After a change you must close and reopen writelog. This info in
stored in Writelog.ini.
Hope that helps
Just got thru a new computer set up with multiple sound cards. Couldn't fir
a USB one that had the required funcitons, so went back to PCI
Ric KV1W
-----Original Message-----
From: writelog-bounces@contesting.com
[mailto:writelog-bounces@contesting.com]On Behalf Of Kevin der Kinderen
Sent: Saturday, November 05, 2005 9:00 AM
To: writelog@contesting.com
Subject: [WriteLog] Sound Card Setup for CW
I'm struggling to figure out how to set up my soundcard to send CW in
writelog. I'm able to get it done in MixW and can run RTTY, etc.
In WriteLog I cannot figure out how tell Rttyrite which sound card to use (I
have three in this machine). The WriteLog CW Receiver window shows no signal
and transmitting has no audio output.
Where do I tell WL to use a specific soundcard?
Kevin - K4VD
Kevin der Kinderen
http://kj4qf.net/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|