When I select a spotted station with the cursor, the call pops normally in
the field and since I have rig control with my FT1000D, the frequency changes
and the bandwidth will change to the 500 hertz setting when I am operating CW.
What I want to stop, is the software going to the 500 hertz setting for
bandwidth. I have no filter in that slot so I have to click either the 250,
2k
or 2.4K button to hear the signal. Is there a setting for the .ini file that
affects this situation? Thanks.
73 Mike N5MT
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|