CW with PK-232 gang,
When I set up Writelog v.10.51M for CW contests using my Timewave PK-232 DSP
I have three problems.
In the port setup if I uncheck 'All modes PTT on CW port RTS" there is no
way to save this configuration. Only an observation and I am not sure if
this is valid for my problems listed below.
The second problem is no QSK. Yes, I have gone to the CW PTT Setup and
checked "None (e.g. QSK)".
Last which is the most annoying, during the contest eventually the MULT
light on the TNC starts blinking and CW output keying to the rig stops. I
then have to turn off/on the TNC to start CW once again, only to have it
fail a little later.
Would it be possible for some of you good fellows try the above and let me
know what you observe. If there is a problem I am sure Wayne would like to
know. I am quite sure I never had this problem before this version (10.51M)
and possibly it has been fixed since, though I can not find an upgrade
history on the Writelog website.
If the above problems have been fixed with the later versions please let me
know.
Many thanks,
Eric - VE3GSI.
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|