Maybe someone could help me figure out what I'm doing
wrong or what's wrong...
SO2R setup with WL and W5XD keyer works fine. I just bought
another TS-2000 so I have a matching pair of rigs for contesting.
COM1 was my old Icom serial port - I attach an RS232 from
the PC to the new rig for rig control. The original TS-2000
uses COM2 thru the W5XD keyer.
I have no problems with CW to radio L/R....but I cannot seem
to get WL to recognize the COM1 port radio for rig control
(no frequency readout, just "kHz CW" on the little box.)
When I order it to log the frequency of QSO's on COM1,
it does nothing.
I have swapped the cables - both rigs will provide WL the
operating frequency when run thru the W5XD keyer - on
either com1 or com2 - but not straight from the PC to
the radio.
Do I need a different type of cable? Any ideas are appreciated.
Thanks
Jamie NS3T
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|