I'm trying to get set up for the rtty roundup with so2r
rtty.
For the first time, I am trying to use the A/B relay for
some special antenna switching, but when I transmit rtty on
rig a, the A/B relay drops out. The relay is normally open
whenever rig b is selected, so there is no problem with rig
b. It is not an RF problem, because it happens even if I
disconnect PTT to the two rigs.
I am using DirectIO, and in setup/ports I have only DVK
(sound card or none) selected for LPT1. The A/B relay
follows the rig A/rig B entry window just fine. The dropout
occurs only when sending a rtty message on rig A.
Any ideas? Thanks in advance.
Dave Hachadorian, K6LL
Yuma, AZ
.
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|