Bob Tracey (Of the FlexRadio software team) has added the code to PowerSDR
enabling the KY Kenwood command that sends cw.
Both in WinWarbler and also Writelog.
I can now use all my cw buffers for DXing/Contesting.
(rtty always worked)
You must be using the Beta testing SVN 1307 version.
I set up my ComPorts for both programs as below.
Thanks to Dave and Bob for discovering and fixing the code.
I am happy to report that:
WinWarblers CW module with these parameters.
CW page set to Xcvr Ctr SW (enabled)
PTT assert PTT during CW (disabled)
PTT page set to Xcvr Ctrl SW (enabled)
PTT set to com 4 (indicated as unused)
(com 6 <> com 3) via VCOM (Com 6 is the PSDR Cat port)
(com 9 <> com 4) via VCOM (Com 9 is the PWSDR PTT Control port)
Writelog works with this combo
PowerSDR Cat Ctrl set to com 6 which in Writelog is Com 3 (Kenwood)
PTT is still com 9 (which via Vcom is com 4)
DSP>Keyer is
Primary Com11 which is Writelog CW Rttyrite Port 7
Secondary Cat which is Still Writelo Port 3 in the Rig Control Ports module
My N8VB vCom setup is/remains
com6 - com3
com9 - com4
com10 - com5
com11 - com7
com12 - com8 (unused at this time)
Thank you Bob....I will be giving the 1000 a challenge during the IARU
contest this weekend.
cw only of course....
-----------------------------------------------------
It's easier to get older than it is to get wiser.
-----------------------------------------------------
Bill H. in Chicagoland
webcams at http://76.16.160.118:8080/
weather at http://hhweather.webhop.org
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|