My writelog software now works on any mode RTTY CW SSB including macros.
But I have a problem WITH SSB TX when I add insulation transformers (one on RX
the other on TX ) in the computer audio output ( there is two transformers 1:1
at 600 / 900 ohms in a small box wired in parrallele with only two wires to the
stereo connectors, one wire to the tip, the other to the ground side, and I
respected the primary and secondary polarities ) ...? .
I did'nt connect a secondary line side to a resistor or any other part as
mentionned in articles ((( because it was working like that before, no more
then two weeks ago when I decided to use shielded wires which was'nt before (
was smal lamp cable )
In RTTY & CW I have RX & TX but not in SSB... ?
Is there soemeone that an idea
Gilles ve2lx
=============
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|