When exporting your log as a cabrillo file, did you see a pop-up message box
asking you to "Use Contest Parameter Setup First"? If so and you clicked
OK, the next pop-up entry box had a field for your name and for your SPC.
If you entered your full name--and not the name you used in the
contest--that may be why you are seeing your full name in the Cabrillo log.
I just did a test and that's where it gets the name for the sent name column
of the logsheet.
You might do another File/Export/Cabrillo file to see if those pop-up's will
reappear. They didn't when I tried it. But, I did manage to make them
re-appear only after creating a second naqprtty file, exporting a log with
it, then going back to the original and exporting to cabrillo file where the
pop-ups appeared again and this time I put in my first name only. That
worked.
Or you might go into a good text editor (wordpad or TextPad) and do a
replace the full name with the name you used. Be sure to include the right
number of spaces so the columns are aligned properly--your name should be in
column 42 and the received callsign in column 57.
E.g.,
QSO: 14192 RY 2008-02-23 1849 VE3IFS Cy Stanway ON KG5U .....etc...
QSO: 14192 RY 2008-02-23 1849 VE3IFS Cy ON KG5U
73,
Dale, kg5u
>
> I was able to put in a few hours in the NAQP this past
> weekend and the logging program was just fine. However, when
> I went to make a Cabrillo file, the program includes my first
> and last name in each entry! When I go to upload it at the
> NCJ site for submission, each of the entries has a defect in
> it because the columns do not seem to match what they are
> looking for. Any ideas anyone?
>
> Cy Stanway, VE3IFS
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|