Hi,
Under [Ports] I added the following statements:
ComSlot1=1
ComSlot2=6
ComSlot3=7
ComSlot4=8
The problem is, when I open WriteLog and go to Setup and ports, what I see is
still Com 1, Com 2, Com 3, and Com 4. Its as I am not writing to the correct
Writelog.ini; however, I see that the rig information for the Yaesu on Com 1 is
clearly in the .ini file.
Any suggestions, I have done this in the past and it worked fine, so I am
confused?
/lee K5UN / TO5X
________________________________________________________________
Sent via the WebMail system at k1nt.com
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|