Jerry,
So what has to be changed in Writelog to use the "RC" command to clear the
clarifier?
Jim N7US
-----Original Message-----
From: Jerry Pixton [mailto:jpixton@shentel.net]
Sent: Monday, January 19, 2009 09:00
To: Jim McDonald; writelog@contesting.com
Subject: Re: [WriteLog] Icom RIT *
Jim,
That is what I concluded was going on with my FT2000 during the RU. The %O
function seems to turn RIT Off instead of RIT Clear.
There is a new command format for the newer Yaesu radios using ASCII
commands like the Kenwoods did, instead of fixed block commands like my
FT-1000mp did.
So I see there is an "RC" command that supposedly clears the Clarifier.
There is an "RT" command that turns the Clarifier Off or On. And an "RU"
command to set a plus offset for RIT and an "RD" command that sets a minus
offset for Clarifier (RIT and Tx Clar????)
The radio is acting like an "RT" command was being sent by %O for the
FT2000 instead of an "RC"???
Jerry, W6IHG
At 06:11 PM 1/18/2009 -0600, Jim McDonald wrote:
>I recently replaced my PRO3 with an FT-2000D.
>
>My recollection is that %O used to work properly when I had an FT-1000MP,
>but it's not working the way it should with my FT-2000D. It turns off the
>RIT and doesn't clear the offset instead of clearing it and leaving the RIT
>on, which I think it should do. Am I confused about how it should work or
>is there another command?
>
>Jim N7US
>
>
>
>
>-----Original Message-----
>
>
>There is no RIT zero software command with the Icom rigs. <dag-nab-it!>
>Eric - Ve3gsi
>
> > -----Original Message-----
> > From: Nicholas Roy Smith
> > Sent: January-18-09 3:14 PM
> >
> > Did a fix for the Icom RIT clear ever get done? * ? Or %O for Icom?
> >
> > Just picked up a couple of Icoms and really miss that feature.
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|