The "V" command is internal to the microHAM Control protocol.
It is not useful at the user level but is used for specific
handshaking between an application (like a logging program)
and microHAM Router.
Use of the "V" poll/response is transparent to the user ...
73,
... Joe, W4TV
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com] On Behalf Of Steve Lott
> Sent: Monday, September 07, 2009 1:03 PM
> To: Doug Ferguson
> Cc: writelog@contesting.com
> Subject: Re: [WriteLog] "V" Command?
>
>
> I would also like to know what the "V" Command is
>
> 73 steve
>
> http://www.KG5VK.com
> My Ham Radio Friends
>
>
> On Sat, Sep 5, 2009 at 9:28 PM, Doug Ferguson <thenewt@msn.com> wrote:
>
> > Please excuse my ignorance but what is the
> >
> > "V" command mentioned as being fixed in the
> >
> > new release?
> >
> > Thanks,
> >
> > 73, Doug - N7NM
> >
> > _______________________________________________
> > WriteLog mailing list
> > WriteLog@contesting.com
> > http://lists.contesting.com/mailman/listinfo/writelog
> > WriteLog on the web: http://www.writelog.com/
> >
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|